And I had help
| SkyWolverines.com http://skywolverines.com/ |
|
| Working on the Imp http://skywolverines.com/viewtopic.php?f=2&t=2966 |
Page 1 of 1 |
| Author: | RayNAiken [ Thu Aug 20, 2015 7:13 pm ] |
| Post subject: | Working on the Imp |
Muz must be working on the Imp Attachment: imp.jpg |
|
| Author: | MadMuz [ Fri Aug 21, 2015 6:45 am ] |
| Post subject: | Re: Working on the Imp |
And I had help
|
|
| Author: | elwood [ Sat Aug 22, 2015 6:06 pm ] |
| Post subject: | Re: Working on the Imp |
Yep i feel your pain!! Did you get your brothers car fixed yet? |
|
| Author: | MadMuz [ Sun Aug 23, 2015 5:09 am ] |
| Post subject: | Re: Working on the Imp |
elwood wrote: Did you get your brothers car fixed yet? I have finished all the rust, have ordered a clutch master and slave cylinder and have to get the brake master cylinder rebuilt.... A guy near me re sleeves cylinders with stainless.... once that is done, they never wear out again. Some previous owner has used silicone between the brake master cylinder and booster to try and stop a leak I guess    Other than that, drill a hole in the tow hitch tongue and wire the trailer plug and it will be right to go Hopefully a long way from here   
|
|
| Author: | elwood [ Sun Aug 23, 2015 6:19 am ] |
| Post subject: | Re: Working on the Imp |
And I am sure after all that work, He is going to help you clean out your shed so you can get started on the gyro.........or not. 
|
|
| Author: | MadMuz [ Sun Aug 23, 2015 10:40 am ] |
| Post subject: | Re: Working on the Imp |
This is the van, it is a 1983 Nissan Urvan camper... The red circles show where the rust was..... all gone now  (well killed chemically and covered)  The bottom left corner is completely 1/4" chicken wire (mesh) beer carton, broom handle and bondo (hand shaped/carved)  Looks fantastic (at 20' away)  
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|