Arnie I was looking at the same thing!!!! Which is again probably an overkill but push rods make me feel warm and fuzzy.....
_________________
A walk in the woods helps me relax and release tension. The fact that I am dragging a body should be entirely irrelevant! A simple thank you would have been enough for the morning coffee without all that "how did you get in here" nonsense.
Fri Apr 10, 2015 9:22 am
MadMuz
Site Admin
Joined: Tue Sep 02, 2014 7:45 am Posts: 10129 Location: Poona, Qld, OZZY
Has thanked:21874 times
Been thanked:6221 times
One of the reasons I mounted the camera that way was to look at those vibrations. There is also a lot of vibration in the camera from the wind, which does not help. What I don't know is whether this degree of vibration is normal. I need to borrow one of those cable tension things to see if my cables are tightened to spec. The tail shudder is mostly evident on full power climbout and is actually much betterwith the new prop. I'd be interested to see the same view on other MTO's and other gyros for comparison
Last edited by loftus on Fri Apr 10, 2015 6:29 pm, edited 2 times in total.
Fri Apr 10, 2015 2:04 pm
Gabor
Site Admin
Joined: Sat Nov 02, 2013 2:18 pm Posts: 11382
Has thanked:16461 times
Been thanked:10056 times
Yes definitely would be helpful to see other MTO's vibration and compare before we freak out
_________________
A walk in the woods helps me relax and release tension. The fact that I am dragging a body should be entirely irrelevant! A simple thank you would have been enough for the morning coffee without all that "how did you get in here" nonsense.
Fri Apr 10, 2015 2:35 pm
gyromike
Joined: Tue Nov 05, 2013 11:51 pm Posts: 414
Has thanked:87 times
Been thanked:534 times
It is a cool view...The cables will flop around quite a bit, I used small nylon adel clamps as cable giudes to keep them from flopping against the keel.
You do not have the required permissions to view the files attached to this post.
_________________ It's never too late to be a bad example.
I spent all my money on Bikes, Broads, and Booze, the rest I wasted.
It is a cool view...The cables will flop around quite a bit, I used small nylon adel clamps as cable giudes to keep then from flopping against the keel.
Good idea. Do any of you guys use a tensiometer to adjust cables, if not how do you assess the correct tension? The guy I bought my prop from is going to lend me one, I looked online and they are almost $1000
Fri Apr 10, 2015 4:38 pm
MadMuz
Site Admin
Joined: Tue Sep 02, 2014 7:45 am Posts: 10129 Location: Poona, Qld, OZZY
Has thanked:21874 times
Been thanked:6221 times
One thing you don't want Lofty, is the rudder cables in tension all the time, it can pull on the swedges and cause the strands of wire to crack where the wire bends, or at the swedges.... as long as the wires are trapped on the pulley.... let them wobble around, no drama. This allows for the flex of the frame without tightening the cable beyond yield.
At full throttle, nothing will stop a tail shaking... I would too if I was that close to the prop as long as when you back off a tad it stops.... and nice smooth cruise, all is good A small alloy trim tab might arrest small amounts of shake?
However, remember the old saying.... 'if it aint broke.... don't fix it!'
_________________ I do all of my own stunts..... most of them are even planned!Ok, Ok.... some of them are planned..
If electricity comes from ELECTRONS, then surely morality comes from MORONS??
A walk in the woods helps me relax and release tension. The fact that I am dragging a body should be entirely irrelevant! A simple thank you would have been enough for the morning coffee without all that "how did you get in here" nonsense.
Users browsing this forum: No registered users and 1440 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum